Mail (Deprecated) Tab

Settings on this tab can be configured so that a notification email is sent when milling finishes, when an error occurs, or when maintenance is complete. When more than one machine is connected, all of the machines become the targets for the settings.

Select the Use mail notification check box to enter each item.

After changing the settings, click OK to save the changes and close the Settings window.

Receiver address

Enter the receiver's email address. You can enter multiple addresses by separating them with commas.

Sender address

Enter the sender's email address. Enter the email address used on the computer on which VPanel is installed.

Server host name

Enter the name of the outgoing mail server (SMTP server name) for the email address entered for the Sender address.

Server port number

Enter the port number of the outgoing mail server for the email address entered for the Sender address.

Use SSL connection

Select this check box to use a security-protected connection (SSL). Select or clear this check box according to the settings of the outgoing mail server for the email address entered for the sender's address.

Use SMTP authentication

User name / Password

Select this check box to perform authentication before sending emails. Input the user name and password for authentication. Select or clear this check box according to the settings of the outgoing mail server for the email address entered for the sender's address.

Send test

Click this button to send a test email to the address entered in Receiver address. If the email is received, the configuration of the settings is complete.

If the sending of the email fails, the message "The email could not be sent." will be displayed. Check the content in the input fields again.

Notification timing

Select the times that email will be sent.