The Image Is Uneven

If no head cap is attached, then attach a head cap and perform imprinting. If you're using material that can be damaged by imprinting with the head cap attached, then replace it with material that has a level imprinting surface.

If no head cap is attached, then attach a head cap and perform imprinting. If you're using material that can be damaged by imprinting with the head cap attached, then replace it with material that has a level imprinting surface.

Performing overstriking with the material left loaded at the same location may improve the image quality. Try performing overstriking with different settings for Gamma, Brightness, or Contrast in the Preview window.

Bidirectional imprinting can shorten the imprint time, but the image quality may suffer. If this happens, go to the METAZA Driver setting window and clear the selection for Bidirection, then redo imprinting.

Attractive imprinting may be impossible if the marking pin becomes worn. Check the state of the marking pin. If the marking pin becomes worn, replace the head with a new one.