Striking is performed, but nothing is imprinted.

Prepare and use imprintable material.

If you're not using a head cap, check if the head position matches the surface height of the material. Imprinting cannot be performed if the head position does not match the height position of the material. Adjust the head position and then tighten the knob firmly.

If nothing is imprinted and changing the location where the material is loaded, the parameters for the material, or the height of the head unit does not correct the problem, then the marking pin may be bent or broken. Try changing to an unused marking pin and carry out test imprinting. If you can imprint with the new marking pin, it means the marking pin you were using is bent or broken. Continue using the new marking pin.