Moving the Machine

Attaching the Retainers to the Machine

When moving the machine, be sure to attach the retainers. Remove the retainers attached to the back of the machine during its installation, and then attach them according to the following procedure. Moving the machine without attaching the retainers may result in damage to the machine.

Procedure
  1. Switch on the power to the machine.
  2. Remove the table, center vise, or clamp pin.
    MPX-90S_RemoveTable
  3. Attach a head cap to the tip of the head.
    MPX-90S_Install_HeadCap
  4. Switching off the power.
  5. Hold down the Power/Movement button for one second or longer.

    The head moves as shown in the following figure.

    MPX-90S_PowerON_wOpeningCover
  6. Loosen the knob.
    MPX-90S_CenterVise_LoosenKnob
  7. Tighten the knob as lifting the head.
    MPX-90S_TightenKnob_wLiftupHead
  8. Unplug the cables.
    MPX-90S_RemoveCable
  9. Attach the retainers.

    Secure the retainers in three locations with five screws. Attach all the retainers and tighten the screws with the included hexagonal wrench.

    MPX-90S_InstallingRetainer
  10. Close the cover.
  11. Repack the machine in the original package.