Extending the Cutting Area

Extending the cutting area allows for maximum material usage.
MEMO Depending on the design to be cut, the pinch rollers may pass over the top of the cutting line.
Procedure
  1. Press [MENU] several times to display the following screen.
    MEMO

    When the material is loaded, follow the following procedure to display the screen.

    1. Press [MENU] several times to display the following screen.
    2. Press [▼].
  2. Press [▶].
  3. Press [▲][▼] to display the following screen.
    MENU_EXTEND_00mm
  4. Press [▶].
  5. Press [▲] or [▼] to select a value.
    MENU_EXTEND_00mm_00mm
    IMPORTANT
    • The set value is applied to both ends of the cutting area.
    • If "EXTEND" is set after loading material, the "W" value displayed on the operation panel will differ from the actual cut width.
    Figure 1. Example: When setting from 0 mm (0 in.) to 10.0 mm (0.39 in.)

    GS2_Expand-CuttingArea
    200 mm
    220 mm (8.66 in.)
    10 mm
  6. Press [ENTER] to select the setting.
  7. Press [MENU] to return to the original screen.
    MEMO
    • Factory default setting: 0.0 mm
    • Setting range: 0.0 to 10.0 mm (0.0 to 0.39 in.)