Adding Jobs That Perform Only UV Lamp Illumination after Printing

This section explains how to duplicate a job to add a job that performs only UV lamp illumination. This procedure is useful in situations such as when you want to retain a job to print as a separate job. Adding a job where only UV lamp illumination is performed after printing will efficiently allow additional UV illumination.

Depending on the model you are using, this setting may be disabled.

Procedure
  1. Use one of the methods below to create a UV Post Cure Job.
    • Right-click the job to duplicate, and then click Edit Design - UV Post Cure Job.
    • With the job to duplicate selected, click VW7_JobMenu1 on the left side of the job tool area, and then click VW7-ICON_UV irradiation job UV Post Cure Job.
    The job is duplicated, and the duplicate job performs only UV illumination. The VW7-ICON_UV illumination job icon is added to the job name field.

    If there are multiple jobs in the job list, the duplicate job is added at the bottom of the list.

    MEMO If you want to perform only UV illumination after printing, group the jobs before outputting them.Outputting Multiple Jobs at Once
  2. If necessary, change the job name.
    1. Right-click the job to copy and click Edit Design - Rename.
    2. Change the name in the Rename window.
    3. Click OK.
      The Rename window closes.