Setting the Drying Time after Printing

You can set the time to dry out the media by setting the time (in minutes) to wait before printing the next page or cutting after a printing operation finishes.

For example, when you need the printed surface to be completely dry when performing printing and cutting (print & cut), it is effective to set a long drying time.

Depending on the model you are using, this setting may be disabled.

Procedure
  1. Perform the operation shown below according to what is being set.
    • Job
      • Double-click the job to set.
      • Right-click on the job to set, then click Edit Design - Job Settings .
      • With a job selected, click VW7_JobMenu1 on the left side of the job tool area, and then click VW7_CustomizeJob Settings .

      The Job Settings window appears.

    • Queue folder: Click VW7_Customize for the queue folder.

      The Queue Properties appears.

  2. Click VW7_PrinterControl Printer Controls.
  3. Select Use Custom Settings for Other Controls.
  4. Set the Dry Time.
  5. Click OK.
    • Any changes made in Job Settings will be applied, and you will be returned to the main window.
    • When changes are made in Queue Properties:
      • When a message for saving the printing settings appears, click OK.

      • To apply the changes to a job already in the queue folder, right-click on the job and click Copy/Paste Setting Value - Apply Current Queue Settings. The changes are reflected in the layout area of the main window.