Performing Only UV Lamp Illumination

Depending on the media and the printing data, the ink may not be fully cured just by the UV illumination during printing. Also use this procedure to fully cure ink to its center and as post-processing to special printing in which the ink is not fully cured.

Configure the settings so that only the UV illumination matching that performed during printing is performed again after printing. Depending on the model you are using, this setting may be disabled.

Procedure
  1. In the job list, double-click the job.
    The Job Settings window appears.
  2. Click .
  3. Select UV Illumination Only for Operation Mode under UV Lamp Control.
  4. Use Scan Speed to set the print head movement speed.
  5. Click OK.
    The job icon in the job list changes to .
  6. Click .
    Only UV lamp illumination is performed.