Using Media That Wrinkles Easily/Does Not Move Smoothly

This section explains the recommended setting method when using media that wrinkles easily/does not move smoothly. Increasing the Vacuum Power setting reduces wrinkling, while reducing this setting allows weak media to move more smoothly. This setting may not be available depending on your model.
Procedure
  1. Perform the operation shown below according to what is being set.
    • Job: Double-click the job to open the Job Settings window.
    • Queue folder: Click for the queue folder to open the Queue Properties window.
  2. Click .
  3. Select Use Custom Settings for Other Controls.
  4. Set the Vacuum Power.
    Set the intensity of the vacuum that holds the media flat on the platen. Increase the power when the media often gets warped or wrinkled. Decrease the power when using soft media. In this way you may be able to improve the feeding of the media.
  5. Click OK.