Matters Described in System Configuration Section

This section describes the setting items and procedures for the operations using PAM following the installation stage.

Configure the settings in accordance with the operating plan that was decided in "Designing the Work" in the Installation section.

The illustration below shows the flow of data from order receiving to printing.

The operating procedures for configuring this flow of data will be explained below.

1. Set the folder for receiving the order data (print data, order information data, etc.).

   Configuring Input Manager

2. Set the order information to be loaded into PAM.

   Loading Order Information (Input Settings)

3. Create the jigs for pasting print data.

   Creating a Fixing Jig for the Object

4. Enter the jig installation position, and set the print data output position.

   Creating a Print Layout and Positioning the Jigs

5. Register the output device in the RIP.

   Configuring the RIP (VersaWorks)

6. Set the print data output destination.

   Configuring Output Manager