Adjusting the Striking Force of the Marking Pin

You can adjust the striking force of the marking pin by using MPX-90 Head Manager. Pin adjustment involves striking the pattern shown in the following figure.

Prepare a piece of the included test-use imprinting material (brass-plated plates) or other material measuring at least 60 mm (2.37 in.) by 60 mm (2.37 in.).


MPX-90S_SamplePattern

Procedure
  1. Start MPX-90 Head Manager.

    • Windows 11

      1. Click Start.
      2. Click All apps - MPX-90 Head Manager.

    • Windows 10

      1. Click Start.
      2. Click MPX-90 Head Manager - MPX-90 Head Manager.
    MPX-90 Head Manager starts.
  2. Turn on the power to the machine.
    Switching On the Power
  3. Click Readjust Pin.

    Follow the on-screen instructions to perform adjustment for the marking pin.

    MPX-90_HeadManager_ReadjustPin
    1. Set a material using the adhesive sheet and table.
      Loading Material on the Machine
    2. Imprint the adjustment pattern using the head cap.

      If the adjustment pattern fails to be imprinted, refer to the sections given below.

      The Imprinted Location Isn't Where Desired Striking is performed, but nothing is imprinted.
  4. When the work is finished, close MPX-90 Head Manager.