Daily Care
Points to Note on Daily Care
Never use gasoline, alcohol, thinner, or any other flammable material.
Doing so may cause a fire.
Never touch the head immediately after printing has finished.
Doing so may result in burns.
- This machine is a precision device and is sensitive to dust and dirt. Be sure to carry out day-to-day cleaning.
- Never use solvents such as thinner, benzine, or alcohol.
- Never attempt to oil or lubricate the machine.
- Never apply silicone substances (oil, grease, spray, etc.) to the machine. Doing so may cause poor switch contact.
Cleaning the Adhesive Sheet
Buildup of dirt or dust on the adhesive sheet can reduce the adhesive strength, making it difficult to secure material in place. Using the adhesive sheet without removing the dirt or dust may lead to material displacement during imprinting, deteriorating the imprint quality. If the adhesive force has been reduced, then wash the adhesive sheet.
How to Wash
Immerse the adhesive sheet in water, and wash the sheet by gently stroking its surface. If the soiling of the adhesive sheet is severe, wash it using diluted neutral detergent. Rinse thoroughly with water to remove all detergent completely.
- Never scrub the adhesive sheet using a scrubbing pad or sponge.
- Never stretch or bend the adhesive sheet when washing it.
How to Dry
Allow the part to dry completely while keeping it out of direct sunlight.
Cleaning the Body and Cover
Use a cloth moistened with water and wrung well, and wipe the parts gently to clean them.
The surface of the cover is easily scratched, so use a soft cloth.
Cleaning of the Head Cap
Detach the head cap mounted on the machine and remove dirt and dust from the surface and the inside of the head cap. Imprinting without first removing dirt and dust from the head cap may damage materials and/or affect the imprint quality.