Loading Material on the Machine

Procedure
  1. Turn on the power.
    Switching On the Power
  2. Open the cover.
    MPX-90S_OpenCover
  3. Align the center of the knob with the top of the triangle directly below it ( ), and then tighten the knob.

    The stopper is fixed in place. If you perform imprinting while the stopper is loose, the knob might come off due to vibration.

    MPX-90S_Loosen-Tighteen_Stopper_1
  4. Attach a head cap to the tip of the head.

    Attach it while lightly holding the head as shown in the following figure. The head cap is attached correctly when its tab clicks.

    IMPORTANT Even when performing imprinting with no head cap used, attach a head cap at this time. This prevents injuries and material damage due to the marking pin striking your hands or the material when you load the material.
    MPX-90S_Install_HeadCap
  5. Load the table on the machine.

    Fit the tabs () on the base of the table into the holes of the machine ().

    MPX-90S_Set-table
  6. Affix the adhesive sheet to the table.
    Note the following points when affixing the adhesive sheet.
    • Place it straight, aligned with the scale marks on the table.
    • Place it inside the table frame.
    • Be careful not to allow any air bubbles to form between the adhesive sheet and the table.
    MPX-90S_Set-Sheet
    MEMO If the adhesive strength of the adhesive sheet has been reduced, wash the adhesive sheet. Also, be careful not to damage the surface such as by rubbing with too much force. Doing so may damage the surface and reduce its adhesive strength.
  7. Press down lightly on the material to load it.
    MPX-90S_Set_Material-Sheet
    When material is small enough to be placed within the table When material is too large to be placed within the table

    MPX-90S_HandlingMaterial

    Load the material in a way that its center () comes to the center of the scale on the table ().
    MPX-90S_HandlingBigMaterial

    Load the material in a way that the center of the imprinting area () comes to the center of the scale on the table (). If the material tilts, place a support in order to keep the imprinting surface horizontal.