102E-0001The changer has collided with the adapter.

Procedure
  1. Install the adapter in the adapter stocker again.
    Remove any pieces of cutting waste and foreign objects that have affixed to the adapter stocker.Step 2: Attaching the Adapter to the Machine
  2. Clear the error or resume milling.

    • If the error occurred during milling

      • Press the touch sensor on the built-in panel.
      • Milling will resume.

    • If the error occurred while the machine was on standby

      • Hold down the touch sensor on the built-in panel.
      • This will clear the error.