1050-****The operation to read a barcode failed.

Table 1. Situation/Error Cause
  • The adapter ID has not been affixed to the adapter.
  • Dirt has affixed to the adapter ID.
  • Dirt has affixed to the barcode sensor.
Procedure
  1. Hold down the touch sensor on the built-in panel.
    This will clear the error.
  2. Check the status of the adapter ID.
    Check that the adapter ID label has been affixed to the adapter. Remove any dirt that has affixed to the barcode of the adapter ID label.
  3. Clean the barcode sensor.
    Milling area cleaning