103D-0000Milling data error. The milling bur cannot reach the milling position.

Table 1. Situation/Error Cause
If the milling bur is too short, or if the angle of the A axis and B axis are too large, the milling bur may not reach the milling position in the Z direction.
Procedure
  1. Hold down the touch sensor on the built-in panel.
    This will clear the error.
  2. Review the milling bur length and the position of the milling bur holder.
    Step 3: Setting the Milling Bur
  3. Review the CAM settings and decrease the angles of the A axis and the B axis.