105F-****The pressure of the compressed air for blowing away the milling waste is out of range.

Table 1. Situation/Error Cause
The air pressure in the milling area may not be appropriate.
Procedure
  1. Review the regulator settings.
    Step 4: Adjusting the Pressure of the Compressed Air
  2. Clear the error or resume milling.

    • If the error occurred during milling

      • Press the touch sensor on the built-in panel.
      • Milling resumes.

    • If the error occurred while the machine was on standby

      • Hold down the touch sensor on the built-in panel.
      • This will clear the error.
Table 2. If the Error Occurs Again
Contact your authorized Roland DG Corporation dealer.