Do not loosen screws with a torque screwdriver with the sleeve () attached.
Doing so may damage the sleeve. Before loosening screws, remove the sleeve from the torque screwdriver.
IMPORTANT
Before tightening a screw that has a specified tightening torque, be sure to attach a sleeve. Check the marking on the sleeve () and use a sleeve that matches the tightening torque value.
Failure to attach a sleeve will cause a torque in excess of the permitted amount to be applied, which may damage parts and materials.
Procedure
Attach the milling bur holder to the milling bur positioner.
Orient the milling bur holder as shown in the figure, and then insert and attach the milling bur holder so that it reaches the back of the hole.
Attach the milling bur holder with its screw hole () on top.
IMPORTANTBe sure to use the included milling bur holder. Failing to do so may affect the milling quality or lead to milling bur damage during milling.
Slide the milling bur through the milling bur holder and determine the proper position.
Insert the milling bur as shown in the following figure and make sure that both ends are within the areas of the milling bur positioner holes.
Attach the 0.3 N·m onto the torque screwdriver.
IMPORTANTBe sure to use the 0.3 N·m torque screwdriver sleeve. Failing to do so may lead to the screw becoming loose during milling or may make it impossible to remove the screw from the milling bur.
Use a torque screwdriver with the sleeve attached to tighten the mounting screw.
Set the milling bur in the ATC magazine.
Firmly insert the milling bur as far as possible. Up to 15 milling burs can be loaded. The milling bur stocker numbers are inscribed on the surface of the ATC magazine.
