Step 4: Remove the detection pin and the automatic correction jig.

Once correction is complete, remove the detection pin and the automatic correction jig, clean them, and then store them.
Procedure
  1. Open the front cover.

    Hold the parts shown in the figure with both hands and open the cover.

    DWX-43W_main_10
  2. Remove the rotary axis correction jig.
    DWX-43W_autoCorrection_03-1
  3. Remove the ATC magazine correction jig and detection pin for correction.
    DWX-43W_autoCorrection_02-2
  4. Close the front cover.
  5. Store the detection pin and the automatic correction jig in the storage ().
    DWX-43W_main_04_1

    Before use, wipe well using a clean, dry cloth, and make sure that no dust, rust, or scratches are found.

    The automatic correction jig being damaged, dirty, or rusted will make it impossible to make accurate detections. This may affect the milling results and may even lead to machine damage.

MEMO

To check whether the following symptoms have been improved, actually output milling data.

  • When the milling position is misaligned
  • When symptoms such as a line of level difference or a hole in the Z direction occurs in the milling results