When Maintenance Is Required

When installing the machine Perform Spindle Run-inCorrecting the Milling Position
When replacing the spindle unit
When the machine has not been used for a prolonged period Perform Spindle Run-in
When moving the machine to a different installation site Correcting the Milling Position
When the milling position is misaligned
When symptoms such as a hole in the Z direction occur
When a milling bur replacement error occurred
When the work time exceeds 20 hours Replacing the CoolantCleaning the Coolant Nozzle
When 14 days have passed since the last coolant replacement
When water or dust accumulates on the regulator Regulator Maintenance
When milling waste or dirt has accumulated inside the machine Preventing Adhering of Milling Waste (Flushing)