Step 1: Cleaning the Detection Points for Use During Correction

Procedure
  1. Open the front cover.

    Hold the parts shown in the figure with both hands and open the cover.

    DWX-43W_main_10
  2. If milling burs are set in the ATC magazine, remove all of them.
    CAUTION

    Be careful around the tip and other sharp edges.

    Be careful not to touch the tool tip or any other sharp edges. Doing so may cause injury.

    MEMO

    When the milling bur is difficult to remove, use the milling bur removal jig.

    Insert the tip of the milling bur into the tip (the narrow end) of the milling bur removal jig, and then push the milling bur up to remove it.

    DWX-43W_autoCorrection_04
  3. If any included holders or attachments are installed at the workpiece mounting part, remove all of them.
  4. If the inside of the machine is wet, wipe it off with a clean, dry cloth.
  5. Use the cloth for care and maintenance to wipe the locations shown in grey in the figures below clean of dirt.

    If any dirt is present in these locations, it may not be possible to perform the correction properly.

    DWX-43W_autoCorrection_01