Step 2: Attaching the Automatic Correction Jig

Procedure
  1. Attach the ATC magazine correction jig to the rotary axis unit.

    Align the holes in the ATC magazine correction jig with the projections on the rotary axis unit, and secure them with screw A ().

    DWX-43W_autoCorrection_05
  2. Push the detection pin for correction () as far as it will go into stocker number 4 in the ATC magazine.

    The tapered (slanted) end is the top of the detection pin for correction. Be careful not to confuse which side is up and which is down.

    IMPORTANT

    Pay attention to the position where the detection pin for correction is pressed in.

    If the detection pin for correction is pressed into a stocker in the wrong position, impact will occur during operation and the machine may be damaged.

    DWX-43W_autoCorrection_05-1
  3. Attach the rotary axis correction jig to hole "2" on the rotary axis.
    1. Align the recessed portion of the jig with the protrusion on the rotary axis, and then insert the jig.

      Ensure that there is no gap between the mounting surfaces. It does not matter which of the two recesses on the jig is aligned to the protrusion.

      DWX-43W_autoCorrection_02-1
    2. Use a T-shaped hexagonal screwdriver to secure the rotary axis correction jig in place with a mounting screw.
      DWX-43W_autoCorrection_03
  4. Close the front cover.