Preventing Adhering of Milling Waste (Flushing)

To prevent milling waste from adhering to the inside of the machine, it performs a regular flushing operation, which automatically cleans the inside of the machine once every 12 hours from the point the machine is turned on.

You can also perform flushing manually when needed.

Situations Requiring This Work
  • When milling waste or dirt has accumulated inside the machine
Procedure
  1. Check that the workpiece, milling burs, correction jigs, and other such items are not installed in the machine.
  2. Close the front cover.

    Hold the parts shown in the figure with both hands and close the cover.

    DWX-43W_main_09
  3. Show VPanel.
  4. Open the Machine settings window.
    1. In the top window of VPanel, select the machine to operate.
      When you have connected multiple machines, you can switch to a different machine to operate by clicking its image under MACHINE STATUS.
    2. Click Icon_VPanel_MachineSetting.

      The Machine settings window is displayed.

      VPanel_Main_MachineSetting
  5. On the Maintenance tab, click Rinse.
    VPanel_DWX-43W_Rinse_01
  6. Click Next.

    Flushing starts and the inside of the machine is cleaned.

    VPanel_DWX-43W_Rinse_02
  7. When a message indicating that the operation is complete appears, click Complete.