Set the size of the material.

This section explains how to set the size of the media to be used on the queue folder.
Procedure
  1. Click VW7_Customize for the queue folder to configure settings.
    The Queue Properties window appears.
  2. Click VW7_Layout Layout.
  3. When media is set up on the printer side, click Get Media Width in Media Settings.

    VersaWorks obtains the information about the width of the printable area from the printer, and W is set. W and H are set for the flat table model.

  4. When media is set up on the printer side, follow the procedure below and set the media size.
    1. From the Size list, select CustomROLL or CustomCUT.
    2. Set the W.
      CustomCUT and H can be set when W is selected.
  5. Click OK.
    When a message indicating that the printing settings were changed appears, click OK. The Queue Properties window closes.
    MEMO These settings can also be customized per job using the Job Settings window.