Cutting the Media after Output

This section explains how to cut away the media after printing.

Depending on the model you are using, this setting may be disabled.

Procedure
  1. Perform the operation shown below according to what is being set.
    • Job: Double-click the job to open the Job Settings window.
    • Queue folder: Click for the queue folder to open the Queue Properties window.
  2. Click .
  3. Select the Cut Sheet after Output check box.
    MEMO Depending on the model, you may be able to select Perforated Sheet Cutting.
  4. Click OK.
    • Any changes made in Job Settings will be applied.
    • When changes are made in Queue Properties:
      1. A message that printing settings will be overwritten appears. Click Yes.

      2. To apply the changes to a job already in the queue folder, select the job and click 1_2_2_4_clear_a.