Setting the Drying Time after Printing

You can set the time to dry out the media by setting the time (in minutes) to wait before printing the next page or cutting after a printing operation finishes.

For example, when you need the printed surface to be completely dry when performing printing and cutting (print & cut), it is effective to set a long drying time.

Depending on the model you are using, this setting may be disabled.

Procedure
  1. Perform the operation shown below according to what is being set.
    • Job: Double-click the job to open the Job Settings window.
    • Queue folder: Click for the queue folder to open the Queue Properties window.
  2. Click .
  3. Select Use Custom Settings for Other Controls.
  4. Set the Dry Time.
  5. Click OK.
    • Any changes made in Job Settings will be applied.
    • When changes are made in Queue Properties:
      1. A message that printing settings will be overwritten appears. Click Yes.

      2. To apply the changes to a job already in the queue folder, select the job and click 1_2_2_4_clear_a.