Using Media That Wrinkles Easily/Does Not Move Smoothly

Set the intensity of the vacuum that holds the media flat on the platen. Increase the Vacuum Power when rigid media gets warped or lifts up after wrinkling and decrease it when using media soft and smooth media. In this way, you may be able to improve the feeding of the media. It may be possible to configure advanced settings for the suction fan from the printer side.

Depending on the model you are using, this setting may be disabled.

Procedure
  1. Perform the operation shown below according to what is being set.
    • Job: Double-click the job to open the Job Settings window.
    • Queue folder: Click for the queue folder to open the Queue Properties window.
  2. Click .
  3. Select Use Custom Settings for Other Controls.
  4. Set the Vacuum Power.
  5. Click OK.
    • Any changes made in Job Settings will be applied.
    • When changes are made in Queue Properties:
      1. A message that printing settings will be overwritten appears. Click Yes.

      2. To apply the changes to a job already in the queue folder, select the job and click 1_2_2_4_clear_a.