Setting the Heater/Dryer Temperature

Normally, the settings for the media-drying devices such as the printer's heater and dryer are configured from the printer. Therefore, the default option for Printer Controls - Heater Controls is Use Printer Settings. In addition, Use Default Media Settings may be the default option depending on the model.

However, you can set the temperature of the heater and dryer while configuring the various settings in VersaWorks.

Depending on the model you are using, this setting may be disabled.

Procedure
  1. Perform the operation shown below according to what is being set.
    • Job: Double-click the job to open the Job Settings window.
    • Queue folder: Click for the queue folder to open the Queue Properties window.
  2. Click .
  3. Select Use Custom Settings for Heater Controls.
    The check boxes will be selected, and you can set the temperatures of the devices. Clear the check boxes to turn off the devices. Depending on the model you are using, some setting items may not be displayed.
    • Pre Heater
    • Print Heater
    • Dryer
  4. Click OK.
    • Any changes made in Job Settings will be applied.
    • When changes are made in Queue Properties:
      1. A message that printing settings will be overwritten appears. Click Yes.

      2. To apply the changes to a job already in the queue folder, select the job and click 1_2_2_4_clear_a.