Step 2: Passing the Media Through the Printer

Procedure
  1. Check that the printer's loading lever is in the up position.
  2. Switch on the printer's sub power.
  3. Check that the following menu items on the printer have been set to "DISABLE".
    • "PREFEED": Models that are equipped with a cutting function
    • "FEED FOR DRY": Models that are equipped with a print heater function
    MEMO For details on how to check and change the settings, refer to the instruction manual for your printer.
  4. Press "MENU" then [◀] to return to the setup screen.

    MENU_TOP_SCREEN_SETUP SHEET
  5. Press [◀] or [▶] to select the take-up method.
    Selecting the Take-up Method
  6. Load the roll media onto the printer and lower the loading lever.
    MEMO For details on how to load, refer to the instruction manual for your printer.
  7. Check that the media is loaded as described below.
    • The media is loaded straight.
    • All areas of the media are taut.
    If the media has slack or is bent, raise the loading lever and load once again.
    Media installation status
  8. Press [ENTER].