Length Setting When "TU2" Is Selected

* If you are using the VF2-640, "TU2" is not displayed.

When "TU2" is selected in the printer menu list, no take-up is performed until the output of the piece of data is finished. Therefore, if the length to be output at one time is large, the media may touch the work floor and become soiled. To avoid soiling the media by touching the floor, output in approximately 300 mm (11.81 in.) increments.

Selecting the Take-up Method

Use the software RIP function to output limiting the length.

This section describes "how to output by limiting the length" using VersaWorks. For information on the detailed usage of VersaWorks, refer to the VersaWorks user's manual.

Procedure
  1. Open the Queue Properties window (or the Job Settings window).
    Select the input folder.
  2. Click Paper settings.
  3. Select CustomCUT for Size under Media Settings.
  4. Set H.
    Figure 1. Queue Properties Window
    Input Properties screen
    MEMO The setting item and the method in the Job Settings window are the same as this procedure.