Step 3: Securing the Media on the Paper Tube (Core)

Procedure
  1. Make sure the screen in the figure is displayed.

    MENU_LOAD_SHEET_TU

  2. Press [▼] to feed out the media until the tip of the media reaches the paper tube.

    Check that the media is fed out straight.

    If the media is not feeding straight, perform the loading operation once again.

    Media is fed out 10 mm (0.39 in.) each time you press [▼]. Holding down the key lets you feed out paper continuously.


    Pull out the media straight

  3. Attach the center and both ends of the media to the paper tube (core) using adhesive tape (A) (three locations in total).
    1. While pulling the media so that it does not sag, secure the center of the media.
    2. While pulling the media from the center toward the outer edges, and fix the left and right edges.
      • Take-up with outward curl

        Adhesive tape position (outer winding)

      • Take-up with inward curl

        Adhesive tape position (inner winding)

  4. Press [ENTER].
    The media is fed out and the screen shown in the figure appears.
    MENU_TILT_DANCER_ROLLER_FR
  5. Lower the dancer roller toward the front.
    Check that all areas of the media are taut.
    Push the dancer roller toward you
  6. Press [ENTER].
    The screen shown in the figure appears.
    MENU_CHECK_TU_SETTING