Selecting the Take-up Method
Installing this machine will cause the printer menu list, etc. to change as follows.
It is possible to select the take-up method ("TU", "TU2", or "TU3") on the "SETUP SHEET" screen.
Select the take-up method to match the output method.
| Take-up method | Output method | Description |
|---|---|---|
| "TU" | Printing only * However, the case in which the media is pulled back after printing in order to print on the media again is excluded. | Take-up is performed at the same time as output. The work can be completed in less time than is required with the "TU2" setting. However, this setting causes an error to occur during output performed with cutting operations, so this setting cannot be used in this situation. * When pulling back the media after printing in order to print on the media again, select the "TU2" setting. |
| "TU2"*1 | Cutting only, printing and cutting, cropping and cutting * However, the case in which the media is pulled back after printing in order to print on the media again is included. | No take-up is performed until the output of the piece of data is finished. When the output is finished, the length of media that was output is pulled back and is then taken up. The work time is longer than that for the "TU" setting, but this setting can be used to perform take-up even for output performed with cutting operations. |
| "TU3"*2 | Printing only | Use this method when using media (such as soft packaging) that is not transported by pulling it back. The cutting operation and media cut-off are not possible. |