How to Remove Taken-up Media

CAUTION

Have two or more people available when removing (handling) the taken up media.

Otherwise the media may fall and cause injury.

Procedure
  1. Lower the dancer roller toward the rear.
  2. With the media held down, cut off the sheet.
    For details on how to cut off, refer to the instruction manual included with each printer.
  3. Use the MANUAL switch to take-up the media.
  4. Support the paper tube from below so that it does not fall.
  5. Loosen the arm retaining screw (A) and the arm.
    Loosen the arm fixing screw
  6. Pull the paper tube from the end cap.
    MEMO

    If the arm does not move, it may have dug into the rail slider. Moving the arm back and forth will free it from being stuck and it will become movable once again.

    Remove the paper tube from the end cap