Step 1: Loading the Paper Tube

Procedure
  1. Lower the dancer roller toward the rear.

    Tilt the dancer roller to the back
  2. Loosen the arm retaining screw (A).
    Loosen the screw to a point where the arm can be moved to the left and right.
    Loosen the arm fixing screw
  3. Install the paper tube to the end cap and fix the arm.
    1. Right side: Push the paper tube against the stand leg side end cap and fit it securely.
    2. Left side: Push the arm side end cap against the paper tube and fit it securely.
    3. Tighten the arm retaining screw while pushing the arm forward.
      IMPORTANT
      • Do not overtighten the arm retaining screw.

        Overtightening may make it difficult to remove the arm.

      • Use the paper tube that is included with the roll.

        If a different tube is used, the media may not be taken up because the roll may fail to engage.

      Attach the paper tube and fix the arm