for Macintosh

The current cut conditions can be saved to memory. Eight sets of settings can be saved to USER 1 to USER 8 memories. Overwriting a memory deletes any old conditions it contains.

Procedure

Make sure that the material is load to the machine.
  1. Press several times to display the screen shown in the figure.

  2. Press .

  3. Press .

    The display shows the values of FORCE, SPEED, and OFFSET menus from the left.

  4. Press to select the memory number you wish to save cutting conditions to.

  5. Press .

    The screen below is displayed.

    Press theMENUkey or the key to go back to the screen in the figure.

  6. Though not shown on the display, the UPSPEED (the speed at which the blade moves when not cutting) and cut quality are also saved.

Back Next