for Macintosh

Referring to the Menu Flow Chart as you proceed will help you complete the setting procedure smoothly.

Procedure

  1. Press to select 4-POINT START.

    If using 3 crop marks, select 3-POINT START. The screen below is displayed.

  2. Press .

    The screen below is displayed.

     

  3. Press .

  4. Perform steps 3 to 13 in "Cutting in Tool Mode (2)."
    • Even if you perform all the steps up to step 13 in Cutting in Tool Mode (2), cutting will not start.
      To start cutting, perform step 5 shown below.

  1. When the figure below is displayed, send data from the computer.

    When the machine receives the data, it starts cutting.

  2. Remove the cut material.

    Remove the material to complete the cutting procedure.