2. Mount the workpiece on the pin-type workpiece adapter.

The following figures show the number of workpieces that can be mounted on the adapter according to their sizes. The maximum number of workpieces that can be mounted on the adapter differs depending on the workpiece length ().


DWX-53DC_PinSize_L

Table 1. Example mounting layouts

 ≤ 20 mm (0.78 in.)
Pin_Adapter_L-20

20 mm (0.79 in.) <  ≤ 50 mm (1.96 in.)
Pin_Adapter_L-20-50

50 mm (1.97 in.) < 
Pin_Adapter_L-50
Procedure
  1. Use a torque screwdriver to loosen the screw at the mounting position for the pin-type workpiece.
    MEMO Use the included spare screws when a screw is lost or worn.
    DWX-53DC_PinAdapter_Install_2-1
  2. Mount the pin-type workpiece on the pin-type workpiece adapter.

    Make sure the recessed portion of the pin-type workpiece is oriented downward, align the protrusion of the pin-type workpiece adapter with this recessed portion, and then insert the workpiece all the way in.

    DWX-53DC_PinAdapter_Install_2-2
  3. Tighten the screw using a torque screwdriver.
    IMPORTANT Be sure to use the 0.6 N·m torque screwdriver sleeve. Failing to do so may lead to loose screws during milling, which will affect the milling quality.
    TorqueDriver_Sleeve_06Nm

    Tighten the screws until turning the handle of the torque screwdriver no longer turns the screw bit.

    Check that there is no gap between the pin-type workpiece and the adapter.

    DWX-53DC_PinAdapter_Install_2-3