1. Mount the pin-type workpiece adapter on the adapter.

Procedure
  1. Use a torque screwdriver to loosen the adapter screws (in four locations), turning them approximately four times.
    IMPORTANT

    Use the included spare screws when a screw is lost or worn.

    DWX-53DC_Adopter_Insrall_1
  2. Turn the adapter cap in the direction of the arrows to remove it.
    DWX-53DC_Adapter_Install_2
  3. Mount the pin-type workpiece adapter on the adapter base.
    1. Load the pin-type workpiece adapter () on the adapter base ().
      • Adapter base (): Orient this part so that it looks like a "C."
      • Pin-type workpiece adapter (): Orient this part so the numbers face up.
      DWX-53DC_Adopter_Insrall_4_2
    2. Turn over the loaded adapter, and then align the positions shown in the following figure.

      Attach the pin-type workpiece adapter so that the protrusions on the adapter base () match the positions of the recessed parts on this adapter ().

      DWX-53DC_Adapter_Install_pin_01
    3. Turn over the adapter so that its top faces up, and then check whether the pin-type workpiece adapter has been mounted on the adapter base without any gaps.
      If the parts wobble, check whether the protrusions match the positions of the recessed parts again.
  4. Attach the adapter cap to the adapter base.
    1. Orient the adapter cap removed in step 2 as shown in the following figure.

      Pay attention to the position of the notch.

      DWX-53DC_Adapter_Install_4
    2. Attach the adapter cap to the adapter base, and then turn the cap in the direction of the arrow.
      DWX-53DC_Adapter_Install_pin_4_3
  5. Temporarily tighten the screws (in four locations) with a torque screwdriver so that their seats come into contact with the adapter cap.

    To secure the adapter cap evenly, temporarily tighten the screws before fully tightening them.

    DWX-53DC_Adapter_Install_pin_4_4
  6. Use a torque screwdriver to tighten the screws in four locations in the order shown in the following figure.
    IMPORTANT Be sure to use the 0.6 N·m torque screwdriver sleeve. Failing to do so may lead to loose screws during milling, which will affect the milling quality.
    TorqueDriver_Sleeve_06Nm
    IMPORTANT

    Tighten the screws until turning the handle of the torque screwdriver no longer turns the screw bit.

    To maintain milling quality, secure the adapter cap evenly. Be sure to tighten the screws across the diagonals.

    DWX-53DC_Adapter_Install_pin_4_5