Step 3: Setting the Milling Bur

Table 1. Required items
DWX-53DC_ToolForTable DWX-53DC_ToolAdapter_ForTable DWX-53DC_Toolholder_ForTable DWX-53DC_ToolBiss_ForTable DWX-53DC_TorkDriver_ForTable
Milling bur

Milling bur positioner

Milling bur holder Mounting screw Torque screwdriver (0.3 N·m)
Procedure
  1. Attach the milling bur holder to the milling bur positioner.
    1. Orient the milling bur holder as shown in the figure, and then insert and attach the milling bur holder so that it reaches the back of the hole.

      Attach the milling bur holder with its screw hole () on top.

      IMPORTANT Be sure to use the included milling bur holder. Failing to do so may affect the milling quality or lead to milling bur damage during milling.
      DWX-53DC_ToolAjuster_1
    2. Slide the milling bur through the milling bur holder and determine the proper position.

      Insert the milling bur as shown in the following figure and make sure that both ends are within the areas of the milling bur positioner holes.

      DWX-53DC_ToolAjuster_2
    3. Tighten the mounting screw using a torque screwdriver.
      IMPORTANT Be sure to use the 0.3 N·m torque screwdriver sleeve. Failing to do so may lead to the screw becoming loose during milling or may make it impossible to remove the screw from the milling bur.
      TorqueDriver_Sleeve_03Nm
      DWX-53DC_ToolAdjuster_3
  2. Set the milling bur in the ATC magazine.

    Firmly insert the milling bur as far as possible. Up to 15 milling burs can be loaded. The milling bur stocker numbers are inscribed on the surface of the ATC magazine.

    DWX-53DC_ATC_Millingbur_set