Step 5: Setting Milling Burs to Use in Milling

Use this section to set the milling bur to use in milling from the milling burs loaded in the ATC magazine.

Procedure
  1. Show VPanel.
  2. Open the Milling bur registration window.
    1. In the top window of VPanel, select the machine to operate.
      When you have connected multiple machines, you can switch to a different machine to operate by clicking its image displayed under MACHINE STATUS.
    2. Click Icon_VPanel_MillingBurManagement.
      The Milling bur management window is displayed.
      VPanel_MillingburManagement
    3. Click Milling bur registration.
      The Milling bur registration window is displayed.
      VPanel_MillingburManagement_MillingburRegistration
  3. Select <New Bur>, and then enter under Milling bur info the name, work time, and replacement time information of the milling bur to register.
    Replacement times depend on the type of milling bur or workpiece as well as the milling conditions. Adjust the replacement time value as necessary.
    VPanel_MillingburRegistration_NewBur
  4. Click Add milling bur.
    The milling bur is registered to the list and can now be selected in the Milling bur management window. You can register up to 35 milling burs.
    VPanel_MillingburRegistration_NewBur_Add
  5. Click Close.
    The Milling bur registration window closes.
    VPanel_MillingburRegistration_NewBur_Close
  6. Click Icon_VPanel_MillingBur_Edit next to the number of the stocker in which the milling bur has been loaded.
    VPanel_MillingburManagement_MillingburRegistration_02
  7. Select the milling bur to use in milling from the registered burs, and then click OK.
    The milling bur is assigned, and the work time and replacement time entered at the time of registration are displayed.
    VPanel_MillingburManagement_MillingburRegistration_03
    MEMO

    To perform long-term, continuous milling without changing the type of milling bur, load milling burs with the same specifications in multiple stockers and set the same milling bur name on these stockers.

    If you use the ITC (Intelligent Tool Control) function, when the milling bur being used approaches its replacement time, it is automatically switched with the next milling bur, and milling continues.

    You can set the same name to up to three milling burs.