Partial Execution

PartialExecution00

When the job calculation is finished, select the Partial Execution checkbox and click Save Toolpath to display addition options in CAM.

You can use this option to select the location at which to start the cutting process from within the hierarchical structure of the program.
PartialExecution

There may be cases where you want to start not from the beginning of the program but from a point within the cutting process.

As examples, this section explains two common cases that correspond to this situation.
  • The machine turned off before the program completed, and it was not possible to restart from VPanel on the milling machine.
  • You forgot to select additional detailed operations.
IMPORTANT

Exercise caution when using this function. Shortening the incorrect toolpath may damage the dental prosthesis, cutting bur, or milling machine. DGSHAPE Corporation assumes no responsibility for milling being restarted at the incorrect location when you failed to accurately determine the location at which milling was interrupted. To prevent damage and accidents, be sure to redo cutting from the beginning if you are not fully confident about the location at which to restart.