3. Install the dryer.

IMPORTANT Always have two people to hold and install the dryer.
Procedure
  1. Open the front cover.
  2. With two people, hold the right and left handles of the dryer and install the dryer into the machine.
    Catch the hooks (A) of the dryer on the locations on the machine indicated with (B) in the figure.


  3. Adjust the horizontal position of the dryer to align the bolt attachment holes and temporarily tighten the six bolts.
    MEMO If the dryer holes and the arm B holes do not match, remove the dryer and adjust the position of arm B.
    • If the arm B screw holes are inside the dryer: Loosen the extension apron fixing bolts, and tighten the bolts again while pulling arm B toward the outside.
    • If the arm B screw holes are outside the dryer: Loosen the extension apron fixing bolts, and tighten the bolts again while pushing arm B toward the inside.
  4. Fully tighten the three bolts on the right side as seen from the front of the printer.


  5. Fully tighten the three bolts on the left side as seen from the front of the printer.


  6. Fully tighten the extension cover bolts while pushing the extension cover against the dryer.

    AP-640_TightenEXcoverBolts