Step 6: Installing the Drain Bottle

There are two types of drain bottles: one for CMYK (outside) and the other for the optimizer (inside). The installation procedure is for installing the drain bottle inside, but the same procedure can be used for installing the drain bottle outside.
Procedure
  1. Connect two tubes to the connectors of the machine.
    AP-640_InstallDrainbottle0
  2. Insert the drain bottle stand into the grooves , and then slide it to the right .


    Insert the hooks (A) into the grooves (B), matching the status indicated in the figure.


  3. Insert the tip of the tube into the drain funnel.


  4. Connect the drain bottle stand connector to the unit.


  5. Stand up the drain bottle stand so it is vertical , and then slide it to the left .
    Stand up the drain bottle stand until the hooks come completely free from the grooves.


  6. Fully tighten the two bolts to secure the drain bottle stand.


  7. Install the drain bottle in the bottle stand.


  8. Install the other drain bottle stand, using the same procedure.
    Figure 1. Two drain bottles attached to the machine