1. Attach arm B.

Procedure
  1. Open the front cover.
  2. Position arm B (left) on the left side as seen from the front of the printer.
    Align the protrusions on the machine side with the holes on arm B.


    MEMO There are two different arm B parts: left (A) and right (B). Attach them on the correct sides.


  3. With the protrusions on the machine (A) in the holes on arm B, tighten the two bolts by hand until there is no gap between the machine and the arm.
    Move arm B until these protrusions are in the holes.


  4. Fully tighten the two bolts.


  5. In the same manner, attach arm B (right) to the right side as seen from the front of the printer.