Printer Controls

Sets the printer control method during printing.

Item Description Refer to
General Sets the sheet cut-off after output and page space.  
  Cut Sheet after Output Cuts the sheet after output. Cut Sheet after Output
  Use Custom Settings Changes Page Space. Setting the Space to the Next Printing Start Location
    Page Space Sets the space to the next printing start location.
Feed Calibration Controls Configures the settings in order to alleviate the horizontal bands that occur during printing. Determining How to Alleviate Horizontal Bands
  Use Default Media Settings Printing is performed with the recommended values for the media selected with Media Type under Quality Settings.
  Use Custom Settings Printing is performed with the values set in this window.
  Use Printer Settings Printing is performed with the settings configured on the printer.
    Feed Calibration If you select Use Custom Settings, enter the Feed Calibration.
Other Controls Specifies the control method for Vacuum Power, Dry Time, and Head Height.  
  Use Default Media Settings Printing is performed with the recommended values for the media selected with Media Type under Quality Settings.  
  Use Custom Settings Printing is performed using the Vacuum Power, Dry Time, and Head Height which are set in this window.  
  Use Printer Settings Printing is performed with the settings configured on the printer.  
    Vacuum Power Sets the intensity of the vacuum that holds the media flat on the platen. This can be set when [Use Custom Settings] is selected. Using Media That Wrinkles Easily/Does Not Move Smoothly
      Normal
      Strong
    Dry Time Sets the time (in minutes) to wait before printing the next page or cutting. This can be set when [Use Custom Settings] is selected. Setting the Drying Time after Printing
    Head Height Sets the height of the print head. This can be set when [Use Custom Settings] is selected. Normally do not change this setting. Adjusting Print Head Height to Match Media Thickness
Heater Controls Specifies the Heater Controls setting method. Setting the Heater/Dryer Temperature
  Use Default Media Settings Printing is performed using the settings for each media that were configured with VersaWorks.
  Use Custom Settings Sets the temperature for Pre Heater, Print Heater, and Dryer.
    Pre Heater
    Print Heater
    Dryer
  Use Printer Settings Printing is performed with the settings configured on the printer.
UV Lamp Control Specifies the UV lamp control method.  
  Operation Mode Specifies the target for irradiation by the UV lamp.  
    Print This is the default setting. Printing and UV irradiation are performed.  
    UV Illumination Only You can configure the settings so that only the UV illumination matching that performed during printing is performed again after printing. Performing Only UV Lamp Illumination
    Scan Speed This can be set when UV Illumination Only is selected.  
  Change UV Lamp Illumination Intensity Adjusts the illumination intensity of the printer's UV lamp. Reducing the UV Lamp Illumination Intensity
    Illumination Intensity
Print Size Correction You can correct a shifted printing result by adjusting the horizontal and vertical sizes of the printing data. If you enter the measured sizes (the actual print size) and the expected sizes (the size to be printed), the correction factors can be automatically calculated and easily set. You can also enter the correction factors directly. Correcting the Dimensions in the Printing Results
  Horizontal Enter the correction factors directly.
  Vertical
  Correction Calculator Click this button to display the Correction Calculator window.
    Correction in X-Direction Sets the correction factor for the horizontal direction. Can be set within a range of -5.00% to +5.00%.
      Expected Size Enter the size to be printed.
      Measured Size Enter the measured size of the printing result.
      Correction Factor This is automatically calculated on the basis of the entered values.
    Correction in Y-Direction Sets the correction factor for the vertical direction. Can be set within a range of -5.00% to +5.00%.
      Expected Size Enter the size to be printed.
      Measured Size Enter the measured size of the printing result.
      Correction Factor This is automatically calculated on the basis of the entered values.