Set the size of the material.
Procedure
-
Click
for the queue folder to be used.
The Queue Properties window appears. -
Click
.
-
When media is set up on the printer side, click Get Media Width in Media Settings.
VersaWorks obtains the information about the width of the printable area from the printer and sets W automatically. On the flat table model, W and H are set automatically.
To specify H on models other than the flat table model, select CustomCUT for the Size and input the H.
-
Click OK to close the Queue Properties window.
MEMO These settings can also be customized per job using the Job Settings window.