Setting the Printing Position

Even when the printing position that was set for the printer is not changed, the printing position can be changed in the horizontal and vertical directions with VersaWorks. This setting can be made on the job or on the queue folder.
Procedure
  1. Perform the operation shown below according to what is being set.
    • Job: Double-click the job to open the Job Settings window.
    • Queue folder: Click for the queue folder to open the Queue Properties window.
  2. Click .
  3. Under Position, perform one of the following operations:
    • Enter the values in X and Y.
      • The job is moved by the specified offset in relation to the job list layout area window's upper left corner (lower right of set up media). [X] sets the right distance and [Y] sets the downward distance. The actual printing will be output rotated 180°, so horizontal movement will be to the left and vertical movement will be to the top.
    • Select the Center on the Media check box.
      • When using roll media, the job is moved to the horizontal center of the media. When using sheet media or standard-size media, the job is moved to the horizontal and vertical center of the media.
    MEMO When changes are made in Job Settings, you can check the changed position in the layout area.
  4. Click OK.
    • Any changes made in Job Settings will be applied.
    • When changes are made in Queue Properties:
      1. A message that printing settings will be overwritten appears. Click Yes.
      2. To apply the changes to a job already in the queue folder, select the job and click 1_2_2_4_clear_a. The changes are reflected in the layout area of the top window.

    MEMO If, after printing, you are performing laminating followed by cutting (block & cut), clear the Center on the Media check box. If the Center on the Media check box is selected, the printing and cutting positions may be misaligned.