Introduction

Perform the following operations before starting work.

Target Models

This guide provides the procedure for models that print on objects loaded on the flat table.

The LEF2-200 is used for the figures in the procedure.

Checking the Software to Use

This guide references the following software. The procedures may vary depending on the software used.

  • VersaWorks 6.8.0
  • Adobe Illustrator 2020

Creating Printing Data

This guide only describes how to process printing data to achieve the objectives given in the section titles. Create this data in advance.

Test Printing

Be sure to carry out test printing to check whether satisfactory results are obtained with the created printing data.