Step 2: Make Horizontal Writing on Portrait Material

Place images and text in the set imprint area. This section explains the method of inputting characters horizontally on portrait material.
Procedure
  1. Type in the text to be imprinted, and then adjust how it's laid out.
    Step 3: Enter Text
    METAZAStudio_Vertical_Writing
  2. Change the text size to your preferred size.

    The text must fit within the imprint area.

    Changing the Location, Size, or Angle of Text
  3. Rotate the input text 90° to make it vertical.
    Changing the Location, Size, or Angle of Text
    METAZAStudio_Vertical_Writing_01
  4. Click icon_METAZAStudio_Text.
  5. Press the → key (left arrow key) on the keyboard.

    A blinking cursor appears below the text.

    METAZAStudio_Vertical_Writing_02
  6. Input the remaining text and move the text to the desired position.
    Changing the Location, Size, or Angle of Text
    METAZAStudio_Vertical_Writing_03
    MEMO

    The on-screen imprint area scale corresponds to the scale for the center vise as shown in the figure. Adjust the position of the material on the machine to enable the text to be imprinted at the location you want.

    Loading Material on the Machine
    MPX-90S_PortraitMaterial_memo