2. Attach the object to be printed on.

Procedure
  1. Open the front cover.
    MEMO

    Be sure to hold the handle of the front cover and keep holding it until the cover is completely opened or closed.

    If you do not open and close the front cover gently, it may break or you may be injured.

    CoverOpen2
  2. Secure the object () to be printed on.

    A jig () might be required according to the shape of the object to be printed on.

    The following figure shows an example of using jigs to fit the shape of the object to be printed on.

    JigBall
  3. Close the front cover.
    MEMO

    Be sure to hold the handle of the front cover and keep holding it until the cover is completely opened or closed.

    If you do not open and close the front cover gently, it may break or you may be injured.

    CoverOpen2